A driving position can be programmed or operated using the buttons on the side of the seat or the key. Follow our simple steps below.
NOTE:
- Lumbar support adjustment cannot be programmed.
- A driving position can be programmed to the buttons on the side of the seat and the key in use for driving the vehicle.
- If the vehicle has been serviced and the battery leads disconnected, the programmed seat positions will have been erased. Re-programme the seat positions.
Programming
1. Make sure the parking brake is on.
2. (Automatic transaxle) Make sure the selector lever is in the P position.
3. Start the engine.
4. Adjust the seat and the active driving display to the desired driving position.
5. Press the SET button on the seat until a beep sound is heard 1 time.
6. Perform one of the following settings within 5 seconds of completing step 5 above:
- Programming using a button on the side of the seat
Press the button you want to programme, either button 1 or 2, until a beep sound is heard 1 time.
- Programming using the key
Press the key unlock button until a beep sound is heard 1 time.
NOTE If a beep sound is heard 3 times, the operation is cancelled.
To move the driving position to a programmed position (Using a button on the side of the seat)
1. Make sure the parking brake is on.
2. (Automatic transaxle) Make sure the selector lever is in the P position.
3. Start the engine.
4. Press the programming button for the driving position you want to call up (button 1 or 2).
5. A beep sound is heard when the driving position adjustment is completed.
NOTE: If the driving position movement is not changed, only the beep sounds. A seat position can be called up even with the engine not running.
The driving position adjustment is cancelled in the following cases:
- Any of the seat adjustment switches is operated.
- The SET button is pressed.
- Programming button 1 or 2 is pressed.
- The key lock button or unlock button is operated. The vehicle starts moving.
- The active driving display is adjusted.
-
(Using a programmed key)
1. Unlock the doors by pressing a request switch or the key unlock button.
2. After unlocking the doors, the seat position adjustment begins within 40 seconds of opening the driver's door, and a beep sounds when the operation is finished.
3. Make sure the parking brake is on.
4. (Automatic transaxle) Make sure the selector lever is in the P position.
5. Start the engine.
6. The active driving display adjustment begins.
NOTE: If there is no driving position movement, a beep is not heard.
The driving position adjustment is cancelled in the following cases:
- Any of the seat adjustment switches is operated.
- The SET button is pressed.
- Programming button 1 or 2 is pressed.
- The key lock button or unlock button is operated.
- The vehicle starts moving.
- The active driving display is adjusted.
​
Erasing programmed driving positions (Erasing the driving positions programmed to the key)
1. Switch the ignition OFF.
2. Press the SET button on the side of the seat until a beep sound is heard 1 time.
3. After the beep sounds, press the key lock button within 5 seconds until a beep sound is heard 1 time.
NOTE: If a beep sound is heard 3 times, the operation is cancelled.